Flipsky FSESC 4.12 50A Open Sourse Project Electric Speed Controller for Electric Skateboard/E-Scooter/ebike DIY Accessories SK8 EScooter Regenerative Braking SK8-ESC with High-end Quality Capacitors

Aug 03,2020 06:54:29 UTC

◆ Hardware:V4.12
◆ Firmware: V3.40(Keep upgrated with the latest firmware version)
◆ PCB:4 layers, size: 40*60mm
◆ Current: 50A continuous / 240A peak
◆ Voltage: 8V-60V (Cells: 3-13S LiPo)
◆ Recommended 10S battery
◆ BEC: 5V@1.5A
◆ BEC type: Internal driver support
◆ Timing: Software calibration
◆ Motor control interface: PPM signal (RC servo), analog, UART, I2C, USB or CAN‐bus.
◆ Cutoff Voltage: Programmable
◆ Frequency: PWM input
◆ Governor: No
◆ Weight: 80g
◆ FSESC4.12 Size: 110x40x20mm
◆ Programming card: No
◆ Reverse: Yes The shipping package contains: 1*FSECS4.12 1*Mini USB 1*VESC Sensor Wire 1*Manual

【Open Source Project 】Based upon the ESC Open Source Project and compatible with VESC Software , come with regenerative braking capabilities .
【Easy wire management 】highly modifiable electronic speed controller designed for DIY Electric Skateboards , Custom design but easy wire management
【Reliable and progressive electric braking 】allows you to use sensorless motors to achieve smooth start-up from a stop , It also provides strong reliable and progressive electric braking
【High-end quality capacitors 】 3pcs 68Ouf 63V capacitors to keep ESC perform the sensor cable stable when it speeds up or slows down
【4-layer PCB Board 】The PCB adopts is gold-thickening process with a 4-layer . The thickness of each layer of copper foil is 3OZ, and the total copper foil thickness is 3OZ*4=12OZ